Keeping Bathrooms Warm Without Blinding Your Kids
When you’re designing a heater for a bathroom, an IP65 rating is a good start—it keeps the steam and splashes out of the electronics—but it’s not the hardest part. The real challenge? The light. If you’re heating a room where babies or toddlers are hanging out, you can’t just crank up the wattage to get more heat. If the lamp is too bright, that glare can actually hurt someone’s eyes. It’s a scary thought, and it’s exactly why we don’t just “turn it up.” The trick to the light We handle this by tweaking the filament temperature and using special coatings on the quartz glass. Most basic lamps give off a harsh, blinding white light. To fix that, we shift the energy toward the long-wave spectrum. Basically, we trade a bit of that instant “hit” of heat for a softer glow. You still get the warmth you need to feel cozy, but you don’t feel like you’re staring into the sun. Built for the steam Then there’s the hardware. Bathrooms are brutal on electronics. We use high-temperature gaskets and alloys that won’t pit or rust when the room gets foggy. Inside, we’ve polished the reflector to a mirror finish. This is key because it pushes the heat straight down at the person, rather than letting it waste away by heating up your ceiling. A word of caution on the wiring Here’s the thing: these units pull a lot of power. If you’re putting a few of these in one small bathroom, your circuit breaker is going to feel that startup surge. If your wiring is too thin, you’ll get voltage drops. That doesn’t just make the heater less efficient—it can actually make the wires behind your walls get dangerously hot. Just make sure your contractor uses the right gauge wire. It’s a small detail, but it’s the difference between a warm bathroom and a trip to the electrician.